Installation video:
Below is a two part video showing the installation of one of our semi-frameless shower screens.

Disclaimer: These videos are for information purposes only and are not to be used as a guide for installation. Ark Showers recommends that only trained professionals install our shower doors. Ark Showers warns its customers that the installation of shower doors performed by those who are not professionally qualified or trained to do so could result in serious bodily injury or property damage. Ark Showers accepts no responsibility for such damage or injury resulting from the improper or unauthorized installation of shower doors, or for installation performed by those not employed by Ark Showers.

Part 1 - Mark and drill the holes
Shows you the tools for the job, unpacking the screen, measuring and marking the holes for the mounting bracket, safety considerations and drilling the holes.

Part 2 - Fix mounting bracket and screen in place
Shows how to insert the anchors, apply silicone to the mounting bracket, lining up and fixing the mounting bracket to the wall, moving the shower screen into position and fixing the shower screen to the mounting bracket.

Not shown in Part 2:

1. It is important that once installed the axis of the pivot is perfectly vertical. So, before drilling the holes for fixing the shower screen to the mounting bracket, check that the shower screen is level by holding the spirit level to the vertical edge of the glass. If the screen is not level, adjust using the grey spacers (or additional shims if required) until it is.
   
2. After the shower screen is installed a line of silicone must be applied along the length of the mounting bracket where it meets the wall, to prevent water getting behind the mounting bracket. The bottom seal must be pressed onto the bottom of the glass, to prevent water escaping between the glass and the bath tub. A few drops of dishwashing soap make this job a lot easier!